in favor of having just one set of macros that don't do HOLD/RESUME_INTERRUPTS
(hence, these correspond to the old SpinLockAcquire_NoHoldoff case).
Given our coding rules for spinlock use, there is no reason to allow
CHECK_FOR_INTERRUPTS to be done while holding a spinlock, and also there
is no situation where ImmediateInterruptOK will be true while holding a
spinlock. Therefore doing HOLD/RESUME_INTERRUPTS while taking/releasing a
spinlock is just a waste of cycles. Qingqing Zhou and Tom Lane.
Also performed an initial run through of upgrading our Copyright date to
extend to 2005 ... first run here was very simple ... change everything
where: grep 1996-2004 && the word 'Copyright' ... scanned through the
generated list with 'less' first, and after, to make sure that I only
picked up the right entries ...
As proof of concept, provide an alternate implementation based on POSIX
semaphores. Also push the SysV shared-memory implementation into a
separate file so that it can be replaced conveniently.
existing lock manager and spinlocks: it understands exclusive vs shared
lock but has few other fancy features. Replace most uses of spinlocks
with lightweight locks. All remaining uses of spinlocks have very short
lock hold times (a few dozen instructions), so tweak spinlock backoff
code to work efficiently given this assumption. All per my proposal on
pghackers 26-Sep-01.
IPC key assignment will now work correctly even when multiple postmasters
are using same logical port number (which is possible given -k switch).
There is only one shared-mem segment per postmaster now, not 3.
Rip out broken code for non-TAS case in bufmgr and xlog, substitute a
complete S_LOCK emulation using semaphores in spin.c. TAS and non-TAS
logic is now exactly the same.
When deadlock is detected, "Deadlock detected" is now the elog(ERROR)
message, rather than a NOTICE that comes out before an unhelpful ERROR.
That means you can now set your options in either or all of $PGDATA/configuration,
some postmaster option (--enable-fsync=off), or set a SET command. The list of
options is in backend/utils/misc/guc.c, documentation will be written post haste.
pg_options is gone, so is that pq_geqo config file. Also removed were backend -K,
-Q, and -T options (no longer applicable, although -d0 does the same as -Q).
Added to configure an --enable-syslog option.
changed all callers from TPRINTF to elog(DEBUG)
