something similar a while back, and there are devices in the wild
that otherwise won't attach. This patch is temporary until the
PHY code is further cleared up.
Obtained from: grehan
but was missed. Mark it for gone_in 14.0. The hardware hasn't been
produced or supported in over 20 years, and even back then it was
known to be electrically unreliable and prone to catastrophic failure.
physical/absolute address in FreeBSD, but it looks like the calling
code might be somewhat portable to other OS's that do require this.
Therefore, set the variables to __unused instead of removing the code
entirely.
Add per-Session configurable ping (SCSI NOP) and login timeouts.
Remove the torn down, old iSCSI session quickly, when performing a reconnect.
Reviewed By: trasz
Sponsored by: NetApp, Inc.
Differential Revision: https://reviews.freebsd.org/D34198
Currently there are five quirks the USB stack tries to automagically detect:
- UQ_MSC_NO_PREVENT_ALLOW
- UQ_MSC_NO_SYNC_CACHE
- UQ_MSC_NO_TEST_UNIT_READY
- UQ_MSC_NO_GETMAXLUN
- UQ_MSC_NO_START_STOP
If any of the quirks above are set, no further quirks will be probed.
If any of the USB mass storage tests fail, the USB device is
re-enumerated as a last resort to clear any error states from the
device. Then the USB stack will try to probe and attach the umass<N>
device passing the detected quirks.
While at it give more details in dmesg about what is going on.
Tested by: several
Submitted by: Idwer Vollering <vidwer_fbsdbugs@gmail.com>
Differential Revision: https://reviews.freebsd.org/D30919
MFC after: 1 week
Sponsored by: NVIDIA Networking
Previously when double-clicking on the last word on a line we would
select from the beginning of the word to the cursor position, because
we searched forward for a space character to find the end of a word.
Now, use the end of the line if we do not find a space.
PR: 261553
Reviewed by: markj
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D34339
Previously when double-clicking on the first word on a line we would
select from the cursor position to the end of the word, not from the
beginning of the line. This is because we searched backward for a
space to mark the beginning of a word.
Now, use the beginning of the line if we do not find a space.
PR: 261553
Reported by: Stefan B.
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Some board use dwc phy in MII mode, so do not fail to attach if this is
the case.
Only rockchip code uses the phy mode to program some custom syscon register.
PR: 260848
MFC after: 1 week
Sponsored by: Beckhoff Automation GmbH & Co. KG
Some SoCs does not have a fixed regulator to handle voltage
switching automatically. Add support for voltage switching
through syscon register when necessary. Add new errata flag
indicating missing regulator. Apply errata to SoCs, which are
known to be affected, i.e. LS1046 and LS1012.
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential revision: https://reviews.freebsd.org/D34029
LX2160A is affected by two erratum regarding SDHCI. However this board
has generic compat string in DTS for SDHCI which means erratum cannot
be simply applied. Compare compat string from "/" path with LX2160A
compat string when attaching device and apply erratum.
Reviewed by: mmel, imp
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential revision: https://reviews.freebsd.org/D34028
- Some of the register writes were already done in the generic tuning code.
Remove them.
- Increase the polling timeout. The previous value is probably fine, but since
timeouts are treated as fatal errors increasing it to 200ms won't hurt.
- Rework the HS400 switching code. Make sure that the switch happens at the
right time. Reset the DLL0 block. We need to do that if u-boot has previously
configured the controller in HS400 mode.
- Check current timing before tuning. The tuning devmethod is always called,
even for timings that don't require the tuning procedure.
- Rework software tuning routine code. Use inner formula for clock
divider calculation, as previous one was incorrect.
- Implement custom re-tune procedure.
Co-authored-by: Hubert Mazur <hum@semihalf.com>
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential Revision: https://reviews.freebsd.org/D34027
The errata has to be applied every time after SDHCI_RESET_ALL is done.
Move it from attach to the custom reset routine.
Reviewed by: wma, mmel
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential Revision: https://reviews.freebsd.org/D33981
Create definitions for the Optional Asynchronous Events Supported (OAES)
values. Also adds a helper macro for the common use case of "mask and
shift". E.g.
value = NVME_CTRLR_DATA_OAES_NS_ATTR_MASK << NVME_CTRLR_DATA_OAES_NS_ATTR_SHIFT;
becomes
value = NVMEB(NVME_CTRLR_DATA_OAES_NS_ATTR);
Reviewed by: mav, imp
Differential Revision: https://reviews.freebsd.org/D34300
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
For RISC-V it was always enabled.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33835
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33828
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33827
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33826
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33825
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33824
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33823
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33822
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33821
EXT_RESOURCES have been introduced in 12-CURRENT and all supported
releases have it enabled in their kernel config.
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D33820
