mirror of
https://github.com/opnsense/src.git
synced 2026-03-27 13:13:13 -04:00
a8083b9c0b
One of the fun issues with scanning has been how the existing
ANI values were programmed into the hardware when channels were
changed. If you're on a really crappy channel and ANI has made
you deaf then when you scan you continue to be deaf on all channels.
This code passes in a flag to startpcureceive which in AR5416 and later
is also used to enable ANI. This allows it to know if it's a normal
operation or a scan operation.
This fixes my situation at home where a temporary spot of a device
going deaf due to interference starts scanning and .. can't hear
anything until I restart.
Now, this isn't the full fix - ideally:
(a) all the ANI config and per-channel information would be migrated
to the shared HAL stuff and enabled for all of the NICs;
(b) when a station reassociates and some other error conditions
(like missed beacons, NF calibration failures, etc) a knob
to reset ANI parameters would likely help recovery.
But hey, I'm committing bits of code again! woo!
Tested:
* AR9344 (2G), STA operation
|
||
|---|---|---|
| .. | ||
| alpine-hal | ||
| ck | ||
| cloudabi | ||
| dev | ||
| edk2 | ||
| ena-com | ||
| ipfilter/netinet | ||
| libb2 | ||
| libfdt | ||
| libnv | ||
| libsodium | ||
| ncsw | ||
| ngatm | ||
| octeon-sdk | ||
| rdma/krping | ||
| v4l | ||
| vchiq/interface | ||
| x86emu | ||
| xz-embedded | ||
| zstd | ||