sys/cam/scsi/scsi_all.h:
In struct scsi_extended_inquiry_data:
- Increase the length field to 2 bytes, as it is 2 bytes in SPC-4.
- Add bit definitions for the various Activiate Microcode actions.
- Add the Sequential Access Logical Block Protection support bit,
since we need that in the sa(4) driver. (For modifications
that will come later.)
- Add definitions for the various Multi I_T Nexus Microcode
Download modes.
sys/cam/ctl/ctl.c:
As of SPC-4, a single report of "REPORTED LUNS DATA HAS CHANGED"
is to be given per I_T nexus. Once it is reported, the unit
attention condition should be cleared for all LUNS attached to
an I_T nexus.
Previously that only happened when a REPORT LUNS command was
processed.
This behavior may be different (according to SAM-5) when the
UA_INTLCK_CTRL bits are non-zero in the control mode page but
CTL does not currently support that.
So, in view of the spec, whenever we report a LUN inventory
change unit attention, clear it on all LUNs for that
particular I_T nexus.
Add a new function, ctl_clear_ua() that will clear a unit
attention on all LUNs for the given I_T nexus.
One field in the extended inquiry data that we could potentially
report at some point is the maximum supported sense data length.
To do that, we would the SIM to report (via path inquiry
perhaps) how much sense data it is able to send.
Add comments to explain some of the bits that are set in the
Extended Inquiry VPD page.
Add a few comments to make it more clear which functions handle
various VPD pages.
Sponsored by: Spectra Logic
MFC after: 1 week
e761f855a0