mirror of
https://github.com/opnsense/src.git
synced 2026-04-03 00:15:16 -04:00
a8eacf9329
Modify the GPIO pins only on the Base-T cards and even there drive all of them low instead of putting them in hi-z state. For the rest (this is the common case), directly power off the PLLs of the high speed serdes. This is the simplest method that does not involve or conflict with the firmware but still works with all T4-T6 cards regardless of what's plugged into the port. This fixes a problem where the peer wouldn't always see a link down if it is connected to the device using a -CR4 copper cable. MFC after: 3 weeks Sponsored by: Chelsio Communications |
||
|---|---|---|
| .. | ||
| t4fw-1.26.2.0.bin | ||
| t4fw_cfg.txt | ||
| t4fw_cfg_uwire.txt | ||
| t4fw_interface.h | ||
| t5fw-1.26.2.0.bin | ||
| t5fw_cfg.txt | ||
| t5fw_cfg_fpga.txt | ||
| t5fw_cfg_hashfilter.txt | ||
| t5fw_cfg_uwire.txt | ||
| t6fw-1.26.2.0.bin | ||
| t6fw_cfg.txt | ||
| t6fw_cfg_fpga.txt | ||
| t6fw_cfg_hashfilter.txt | ||
| t6fw_cfg_uwire.txt | ||