Kornel Dulęba 3b8d04f845 igc: Change default duplex setting ... During media selection through ifconfig one might not specify the duplex setting through the mediaopt flag. In that case the igc driver would default to full-duplex. The problem with this approach is that e1000(em/igb) driver defaults to half-duplex. Because of that if one connects both NICs and sets media to e.g. 100baseTX on both of them no link will be found. Fix that by matching igc behaviour with what e1000 does. Reviewed by: grehan Approved by: mw(mentor) Obtained from: Semihalf Sponsored by: Stormshield MFC after: 2 weeks Differential Revision: https://reviews.freebsd.org/D35673		2022-07-01 08:12:08 +02:00
..
if_igc.c	igc: Change default duplex setting	2022-07-01 08:12:08 +02:00
if_igc.h
igc_api.c	igc: Use hardware routine for PHY reset	2021-11-08 23:33:10 +10:00
igc_api.h	igc: Use hardware routine for PHY reset	2021-11-08 23:33:10 +10:00
igc_base.c
igc_base.h
igc_defines.h
igc_hw.h	igc: Update PCI IDs	2022-05-15 15:09:58 -07:00
igc_i225.c	Default to always accepting the PHY that's present. Linux did	2022-02-26 18:29:08 -07:00
igc_i225.h
igc_mac.c
igc_mac.h
igc_nvm.c
igc_nvm.h
igc_osdep.h
igc_phy.c	Fix 'take effect' spelling in menus and comments.	2021-11-18 23:22:12 -07:00
igc_phy.h	igc: Use hardware routine for PHY reset	2021-11-08 23:33:10 +10:00
igc_regs.h
igc_txrx.c	igc: Remove redundant IFCAP_VLAN_HWTAGGING check	2021-12-29 09:37:34 -07:00