USB support
This revision adds USB (EHCI/OHCI/OTG, depending on SoC type) support for
various Ralink/Mediatek SoCs.
Currently USB is not supported on MT7621, this will be a future addition.
A USB PHY driver is also included, so that we can properly initialize the
USB PHY (e.g., clocks, resets, registers where needed), before attempting
to initialize EHCI/OHCI/OTG functionality.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5841
UART drivers.
- uart_dev_mtk.[ch] are the old-style Mediatek/Ralink-specific UART driver
as also found in sys/mips/rt305x/uart_dev_rt305x.c, with minor improvements
and FDT attachment enabled for the appropriate SoCs.
- uart_dev_mtk_ns8250.c is the new-style ns16550a-compatible UART driver
found in newer Mediatek SoCs. It uses the uart_dev_ns8250.c driver
indirectly and is basically just a wrapper around it and only overrides its
probe method.
The reason I am not using the uart_dev_ns8250.c driver directly is because
I have some code that does UART clock detection before initializing the
UART, so that we don't need to hard-code the UART clock frequency in the
dts files for each board.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5840
Interrupt controllers found in various Mediatek/Ralink SoCs.
mtk_intr_v1 and mtk_intr_v2 are basically the same at the moment, with
just different register mappings.
However, v1 interrupt controller has a subset of the functionality of the
v2 interrupt controller, so in the future the v2 interrupt controller driver
may be enhanced, if needed, with things like level/edge interrupts and soft
interrupts. So, for the moment I suggest we keep them as 2 separate files.
mtk_intr_gic provides very basic (similar to v1 and v2) support for MIPS GIC
controllers, which currently maps all interrupts to a single core and sets
them to type level, active high. In the future this may be developed into a
generic GIC controller to support any new MIPS SoCs that include it. The GIC
is a standard MTI interrupt controller in their multi-core line-up (e.g.,
1004K, 1074K, etc.), rather than a SoC-specific controller.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5839
This revision adds the following to the Mediatek/Ralink support:
- initial support for "clocks" FDT property, currently based on fdt_clock
- initial support for "resets" FDT property, currently based on the
fdt_reset interface from D5826
- initial support for "pinctrl,bits" functionality via FDT. May be extended
in the future to cover a better and fuller pinctrl implementation
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5827
- machine dependent low level init code
- SoC clocks detection and some utility functions
- Common interface to read/write/modify SoC system control registers, used
by some of the other drivers and utility functions
- simple FDT resets support, based on the fdt_clock implementation already
in the tree. For the moment resets and clocks are managed using these
implementations. I am planning to port those to the new extres framework
in the future, but currently I simply don't have time to do this part too.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5826
