This function will call the regnode_check_voltage method for a given regulator
and check if the desired voltage in reachable by it.
Also adds a default method that check the std_param and which should be enough
for most regulators and add it as the method for axp* rk805 and fixed regulators.
Reviewed by: mmel
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D22260
This method check that boot_on or always_on is set to 1 and if it
is it will try to enable the regulator.
The binding docs aren't clear on what to do but Linux enable the regulator
if any of those properties is set so we want to do the same.
The function first check the status to see if the regulator is
already enabled it then get the voltage to check if it is in a acceptable
range and then enables it.
This will be either called from the regnode_init method (if it's needed by the platform)
or by a SYSINIT at SI_SUB_LAST
Reviewed by: mmel
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D22106
This was the wrong solution to the problem; regulator_shutdown invokes
regnode_stop. regulator_stop is not a refcounting method, but it invokes
regnode_enable, which is.
mmel@ has a proposed patch/solution to instead provide regnode_fixed_stop
behavior that properly takes shared GPIO pins into account.
regnode::enable_cnt is generally used to refcount regulator nodes. For
GPIOs, the refcount was done on the gpio_entry since more than one regulator
can share a GPIO.
GPIO regulators were not taking part in the node refcount, since they had
their own mechanism. This caused some fallout after manu started disabling
everybody's unused regulators in r331989.
Refcount it.
Glanced over by: manu
For each regulators create an hw.regulator.<regname>. :
uvolt: Current value
always_on: 1 If the reg is always on
boot_on: 1 If the reg is set at boot time
enable_cnt: Number of consumer(s)
enable_delay: Delay before enabling the regulator
ramp_delay: The Ramp delay
max_uamp: The maximum value of the regulator in uAmps
min_uamp: The minimal value of the regulator in uAmps
max_uvolt: The maximum value of the regulator in uVolts
min_uvolt: The minimal value of the regulator in uVolts
Reviewed by: ian
Differential Revision: https://reviews.freebsd.org/D14578
In some cases, the driver must handle given properties located in
specific OF subnode. Instead of creating duplicate set of function, add
'node' as argument to existing functions, defaulting it to device OF node.
MFC after: 3 weeks
support frameworks(i.e. clk/reset/phy/tsensors/fuses...).
The framework is still far from perfect and probably doesn't have stable
interface yet, but we want to start testing it on more real boards and
different architectures.
