The -NOIP builds fail because cxgbe_tls_tag_free() has no prototype (if
neither INET nor INET6 are defined). The function isn't actually used
in that case, so we can just remove the stub implementation.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Keep track of the approximate time commands are 'due' and the next
deadline for a command. twice a second, wake up to see if any commands
have entered timeout. If so, quiessce and then enter a recovery mode
half the timeout further in the future to allow the ISR to
complete. Once we exit recovery mode, we go back to operations as
normal.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D28583
This patch is for the following updates to the K1 configurations:
Tx idle period for entering K1 should be 128 ns.
Minimum Tx idle period in K1 should be 256 ns.
Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
PR: 258153
Reviewed by: erj
Tested by: iron.udjin@gmail.com
Approved by: imp
Obtained from: DPDK (6f934fa24dfd437c90ead96bc7598ee77a117ede)
MFC after: 1 week
Previously, we were collecting at a base rate of:
64 bits x 32 pools x 10 Hz = 2.5 kB/s
This change drops it to closer to 64-ish bits per pool per second, to
work a little better with entropy providers in virtualized environments
without compromising the security goals of Fortuna.
Reviewed by: #csprng (cem, delphij, markm)
Differential Revision: https://reviews.freebsd.org/D32021
Refer to discussion in PR 230808 for a less incomplete discussion, but
the gist of this change is that we currently collect orders of magnitude
more entropy than we need.
The excess comes from bytes being read out of /dev/*random. The default
rate at which we collect entropy without the read_rate increase is
already more than we need to recover from a compromise of an internal
state.
Reviewed by: #csprng (cem, delphij, markm)
Differential Revision: https://reviews.freebsd.org/D32021
Write to the PWREN register should be done in update_ios based
on the power_mode value in the ios struct.
Also none of the manual (RockChip and Altera) and Linux talks about
the needed for an inverted PWREN value so just remove this.
This fixes eMMC (and possibly SD) when u-boot didn't setup the controller.
Reported by: avg
Tested-on: Rock64, RockPro64
In vt_kms, the postswitch callback restores fbdev mode when
panicking or entering the debugger. This ensures that even when
a graphical applicatino was running on the first tty, simple framebuffer
mode would be restored and the panic would be visible instead
of the frozen GUI. But vt wouldn't call the postswitch callback
when we're already on the first tty, so running a GUI on it
would prevent you from reading any panics.
Reviewed by: tsoome
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D29961
Add generic mmc_helper which uses newly introduced device_*_property
api. Thanks to this change the sd/mmc drivers will be capable
of parsing both DT and ACPI description.
Ensure backward compatibility for all mmc_fdt_helper users.
Reviewed by: manu, mw
Sponsored by: Semihalf
Differential revision: https://reviews.freebsd.org/D31598
Generialize bus specific property accessors. Those functions allow driver code
to access device specific information.
Currently there is only support for FDT and ACPI buses.
Reviewed by: manu, mw
Sponsored by: Semihalf
Differential revision: https://reviews.freebsd.org/D31597
Fix device detach and attach routine. Add required Makefile
to build as a module. Remove entry from GENERIC, since now
it can be loaded automatically.
Tested on EspressoBin.
Obtained from: Semihalf
Reviewed by: manu
Differential revision: https://reviews.freebsd.org/D31581
Once the controller has failed, fail all I/O w/o sending it to the
device. The reset of the nvme driver won't schedule any I/O to the
failed device, and the controller is in an indeterminate state and can't
accept I/O. Fail both at the top end of the sim and the bottom
end. Don't bother queueing up the I/O for failure in a different task.
Reviewed by: chuck
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D31341
Various syncs with the e1000 shared code from DPDK:
"cid-gigabit.2020.06.05.tar.gz released by ND"
Approved by: imp
Obtained from: DPDK
MFC after: 1 week
Enabling ulp on link down when cable is connect caused an infinite
loop of linkup/down indications in the NDIS driver.
After discussed, correct flow is to enable ULP only when cable is
disconnected.
Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Approved by: imp
Obtained from: DPDK (4bff263d54d299269966365f9697941eecaa241b)
MFC after: 1 week
During LTO build compiler reports some 'false positive' warnings about
variables being possibly used uninitialized. This patch silences these
warnings.
Exemplary compiler warning to suppress (with LTO enabled):
error: 'link' may be used uninitialized in this function
[-Werror=maybe-uninitialized]
if (link) {
Signed-off-by: Andrzej Ostruszka <aostruszka@marvell.com>
Approved by: imp
Obtained from: DPDK (46136031f19107f4e9b6b3a952cb7f57877a7f0f)
MFC after: 1 week
In function e1000_update_mc_addr_list_vf(), "msgbuf[0]" is used prior
to initialization at "msgbuf[0] |= E1000_VF_SET_MULTICAST_OVERFLOW".
And "msgbuf[0]" is overwritten at "msgbuf[0] = E1000_VF_SET_MULTICAST".
Fix it by moving the second line prior to the first one that mentioned
above.
Fixes: dffbaf7880a8 ("e1000: revert fix for multicast in VF")
Cc: stable@dpdk.org
Signed-off-by: Yong Wang <wang.yong19@zte.com.cn>
Acked-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Approved by: imp
Obtained from: DPDK (f58ca2f9ef6)
MFC after: 1 week
This fixes the timed out for shadow RAM write EEWR can't be detected.
Fixes: 5a32a257f957 ("e1000: more NICs in base driver")
Cc: stable@dpdk.org
Signed-off-by: Chengwen Feng <fengchengwen@huawei.com>
Signed-off-by: Min Hu (Connor) <humin29@huawei.com>
Acked-by: Haiyue Wang <haiyue.wang@intel.com>
Approved by: imp
Obtained from: DPDK (4a8ab48ec47b3616272e50620b8e1a9599358ea6)
MFC after: 1 week
Due timing issues in WHL and since recovery by host is
not always supported, increased timeout for Manageability Engine(ME)
to finish Ultra Low Power(ULP) exit flow for Nahum before timer expiration.
Signed-off-by: Nir Efrati <nir.efrati@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (cf1f3ca45d33e793ca581200b4000c39a798113e)
MFC after: 1 week
Added defines for the EEC, SHADOWINF and FLFWUPDATE registers needed for
the nvmupd_validate_offset function to correctly validate the NVM update
offset.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (2c7fe65ab9a31e6ebf438dad7ccc59bcde83a89f)
MFC after: 1 week
Now the functions are being accessed outside of the file, we need
to properly expose them for silicon families to use.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (df01c0ee277d51f81d7d72501dba97550d3b6c4a)
MFC after: 1 week
This code is required for the update for system clock.
Signed-off-by: Todd Fujinaka <todd.fujinaka@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (3f0188c8f29847038bc9f306b2570ace57e3811c)
MFC after: 1 week
Add two files base.c and base.h to reduce the redundancy
in the silicon family code.
Remove the code duplication from e1000_82575 files.
Clean family specific functions from base.
Fix up a stray and duplicate function declaration.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (44dddd14059f151f39f7e075b887decfc9a10f11)
MFC after: 1 week
Fix typo in piece of code of NVM access for SPT.
And cleans up the remaining instances in the shared code
where it was not adhering to the Linux code standard.
Wrong description was found in the mentioned file, so fix them.
Remove shadowing variable declarations.
Relating to operands in bitwise operations having different sizes.
Unreachable code since *clock_in_i2c_* always return success.
Don't return unused s32 and don't check for constants.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
Signed-off-by: Vitaly Lifshits <vitaly.lifshits@intel.com>
Signed-off-by: Robert Konklewski <robertx.konklewski@intel.com>
Signed-off-by: Doug Dziggel <douglas.a.dziggel@intel.com>
Signed-off-by: Todd Fujinaka <todd.fujinaka@intel.com>
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (b8592c89c8fbc871d22313dcac0b86c89a7d5a62)
MFC after: 1 week
Copyrights in sync with "cid-gigabit.2020.06.05.tar.gz released by ND"
(from DPDK).
README from the latest em-7.7.8 on intel.com
Approved by: imp
MFC after: 1 week
This reverts commit fc7682b17f.
This will be done incrementally to help with bisecting an issue in
later I21x devices (ich8lan).
PR: 258153
Approved by: imp
MFC after: 1 day
When building ENA as compiled into the kernel, the driver would fail to
build. Resolve the problem by introducing the following changes:
1. Add missing `ena_rss.c` entry in `sys/conf/files`.
2. Prevent SYSCTL_ADD_INT from throwing an assert due to an extra
CTLTYPE_INT flag.
Fixes: 986e7b9227 ("ena: Move RSS logic into its own source files")
Fixes: 6d1ef2abd3 ("ena: Implement full RSS reconfiguration")
Obtained from: Semihalf
Sponsored by: Amazon, Inc.
MFC after: 1 week
* Don't reset the entire adapter for vlan changes, fix up the problems
* Add some functions for vlan filter (vfta) manipulation
* Don't muck with the vfta if we aren't doing HW vlan filtering
* Disable interrupts when manipulating vfta on lem(4)-class NICs
* On the I350 there is a specification update (2.4.20) in which the
suggested workaround is to write to the vfta 10 times (if at first you
don't succeed, try, try again). Our shared code has the goods, use it
* Increase a VF's frame receive size in the case of vlans
From the referenced PR, this reduced vlan configuration from minutes
to seconds with hundreds or thousands of vlans and prevents wedging the
adapter with needless adapter reinitialization for each vlan ID.
PR: 230996
Reviewed by: markj
Tested by: Ozkan KIRIK <ozkan.kirik@gmail.com>
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D30002
Due to the quirky nature of the Synopsys Designware PCIe IP,
the type 0 configuration is broadcast and whatever device
is plugged into slot, will appear at each 32 device
positions of bus0. Mitigate the issue by filtering out
duplicated devices on this bus for both DT and ACPI cases.
Reviewed by: mw
Sponsored by: Semihalf
MFC: after 3 weeks
Differential revision: https://reviews.freebsd.org/D31887
Previous code by default setting pre-timeout interval to 120 seconds
made impossible to set timeout interval below that, resulting in error
0xcc (Invalid data field in Request) at least on Supermicro boards.
To fix that limit maximum pre-timeout interval to ~1/4 of the timeout
interval, that sounds like a reasonable default: not too short to fire
too late, but also not too long to give many false reports.
MFC after: 2 weeks
