Once the controller has failed, fail all I/O w/o sending it to the
device. The reset of the nvme driver won't schedule any I/O to the
failed device, and the controller is in an indeterminate state and can't
accept I/O. Fail both at the top end of the sim and the bottom
end. Don't bother queueing up the I/O for failure in a different task.
Reviewed by: chuck
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D31341
Various syncs with the e1000 shared code from DPDK:
"cid-gigabit.2020.06.05.tar.gz released by ND"
Approved by: imp
Obtained from: DPDK
MFC after: 1 week
Enabling ulp on link down when cable is connect caused an infinite
loop of linkup/down indications in the NDIS driver.
After discussed, correct flow is to enable ULP only when cable is
disconnected.
Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Approved by: imp
Obtained from: DPDK (4bff263d54d299269966365f9697941eecaa241b)
MFC after: 1 week
During LTO build compiler reports some 'false positive' warnings about
variables being possibly used uninitialized. This patch silences these
warnings.
Exemplary compiler warning to suppress (with LTO enabled):
error: 'link' may be used uninitialized in this function
[-Werror=maybe-uninitialized]
if (link) {
Signed-off-by: Andrzej Ostruszka <aostruszka@marvell.com>
Approved by: imp
Obtained from: DPDK (46136031f19107f4e9b6b3a952cb7f57877a7f0f)
MFC after: 1 week
In function e1000_update_mc_addr_list_vf(), "msgbuf[0]" is used prior
to initialization at "msgbuf[0] |= E1000_VF_SET_MULTICAST_OVERFLOW".
And "msgbuf[0]" is overwritten at "msgbuf[0] = E1000_VF_SET_MULTICAST".
Fix it by moving the second line prior to the first one that mentioned
above.
Fixes: dffbaf7880a8 ("e1000: revert fix for multicast in VF")
Cc: stable@dpdk.org
Signed-off-by: Yong Wang <wang.yong19@zte.com.cn>
Acked-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Approved by: imp
Obtained from: DPDK (f58ca2f9ef6)
MFC after: 1 week
This fixes the timed out for shadow RAM write EEWR can't be detected.
Fixes: 5a32a257f957 ("e1000: more NICs in base driver")
Cc: stable@dpdk.org
Signed-off-by: Chengwen Feng <fengchengwen@huawei.com>
Signed-off-by: Min Hu (Connor) <humin29@huawei.com>
Acked-by: Haiyue Wang <haiyue.wang@intel.com>
Approved by: imp
Obtained from: DPDK (4a8ab48ec47b3616272e50620b8e1a9599358ea6)
MFC after: 1 week
Due timing issues in WHL and since recovery by host is
not always supported, increased timeout for Manageability Engine(ME)
to finish Ultra Low Power(ULP) exit flow for Nahum before timer expiration.
Signed-off-by: Nir Efrati <nir.efrati@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (cf1f3ca45d33e793ca581200b4000c39a798113e)
MFC after: 1 week
Added defines for the EEC, SHADOWINF and FLFWUPDATE registers needed for
the nvmupd_validate_offset function to correctly validate the NVM update
offset.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (2c7fe65ab9a31e6ebf438dad7ccc59bcde83a89f)
MFC after: 1 week
Now the functions are being accessed outside of the file, we need
to properly expose them for silicon families to use.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (df01c0ee277d51f81d7d72501dba97550d3b6c4a)
MFC after: 1 week
This code is required for the update for system clock.
Signed-off-by: Todd Fujinaka <todd.fujinaka@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (3f0188c8f29847038bc9f306b2570ace57e3811c)
MFC after: 1 week
Add two files base.c and base.h to reduce the redundancy
in the silicon family code.
Remove the code duplication from e1000_82575 files.
Clean family specific functions from base.
Fix up a stray and duplicate function declaration.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (44dddd14059f151f39f7e075b887decfc9a10f11)
MFC after: 1 week
Fix typo in piece of code of NVM access for SPT.
And cleans up the remaining instances in the shared code
where it was not adhering to the Linux code standard.
Wrong description was found in the mentioned file, so fix them.
Remove shadowing variable declarations.
Relating to operands in bitwise operations having different sizes.
Unreachable code since *clock_in_i2c_* always return success.
Don't return unused s32 and don't check for constants.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
Signed-off-by: Vitaly Lifshits <vitaly.lifshits@intel.com>
Signed-off-by: Robert Konklewski <robertx.konklewski@intel.com>
Signed-off-by: Doug Dziggel <douglas.a.dziggel@intel.com>
Signed-off-by: Todd Fujinaka <todd.fujinaka@intel.com>
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
Reviewed-by: Wei Zhao <wei.zhao1@intel.com>
Approved by: imp
Obtained from: DPDK (b8592c89c8fbc871d22313dcac0b86c89a7d5a62)
MFC after: 1 week
Copyrights in sync with "cid-gigabit.2020.06.05.tar.gz released by ND"
(from DPDK).
README from the latest em-7.7.8 on intel.com
Approved by: imp
MFC after: 1 week
This reverts commit fc7682b17f.
This will be done incrementally to help with bisecting an issue in
later I21x devices (ich8lan).
PR: 258153
Approved by: imp
MFC after: 1 day
When building ENA as compiled into the kernel, the driver would fail to
build. Resolve the problem by introducing the following changes:
1. Add missing `ena_rss.c` entry in `sys/conf/files`.
2. Prevent SYSCTL_ADD_INT from throwing an assert due to an extra
CTLTYPE_INT flag.
Fixes: 986e7b9227 ("ena: Move RSS logic into its own source files")
Fixes: 6d1ef2abd3 ("ena: Implement full RSS reconfiguration")
Obtained from: Semihalf
Sponsored by: Amazon, Inc.
MFC after: 1 week
* Don't reset the entire adapter for vlan changes, fix up the problems
* Add some functions for vlan filter (vfta) manipulation
* Don't muck with the vfta if we aren't doing HW vlan filtering
* Disable interrupts when manipulating vfta on lem(4)-class NICs
* On the I350 there is a specification update (2.4.20) in which the
suggested workaround is to write to the vfta 10 times (if at first you
don't succeed, try, try again). Our shared code has the goods, use it
* Increase a VF's frame receive size in the case of vlans
From the referenced PR, this reduced vlan configuration from minutes
to seconds with hundreds or thousands of vlans and prevents wedging the
adapter with needless adapter reinitialization for each vlan ID.
PR: 230996
Reviewed by: markj
Tested by: Ozkan KIRIK <ozkan.kirik@gmail.com>
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D30002
Due to the quirky nature of the Synopsys Designware PCIe IP,
the type 0 configuration is broadcast and whatever device
is plugged into slot, will appear at each 32 device
positions of bus0. Mitigate the issue by filtering out
duplicated devices on this bus for both DT and ACPI cases.
Reviewed by: mw
Sponsored by: Semihalf
MFC: after 3 weeks
Differential revision: https://reviews.freebsd.org/D31887
Previous code by default setting pre-timeout interval to 120 seconds
made impossible to set timeout interval below that, resulting in error
0xcc (Invalid data field in Request) at least on Supermicro boards.
To fix that limit maximum pre-timeout interval to ~1/4 of the timeout
interval, that sounds like a reasonable default: not too short to fire
too late, but also not too long to give many false reports.
MFC after: 2 weeks
For TCP DDP, handle_ddp_close() needs to see the pre-FIN rcv_nxt to
determine how much data was placed in the local buffer before the FIN
was received. The changes in d59f1c49e2 broke this by updating
rcv_nxt before calling handle_ddp_close().
Fixes: d59f1c49e2 cxgbe tom: Permit rcv_nxt mismatches on FIN for iSCSI connections on T6.
Sponsored by: Chelsio Communications
This is similar to the fixes in 141fe2dcee. One difference is that
TOE sockets do not change states (listen vs non-listen) once created,
so no lock is needed for SOLISTENING().
Sponsored by: Chelsio Communications
Move the type and function pointers for operations on existing send
tags (modify, query, next, free) out of 'struct ifnet' and into a new
'struct if_snd_tag_sw'. A pointer to this structure is added to the
generic part of send tags and is initialized by m_snd_tag_init()
(which now accepts a switch structure as a new argument in place of
the type).
Previously, device driver ifnet methods switched on the type to call
type-specific functions. Now, those type-specific functions are saved
in the switch structure and invoked directly. In addition, this more
gracefully permits multiple implementations of the same tag within a
driver. In particular, NIC TLS for future Chelsio adapters will use a
different implementation than the existing NIC TLS support for T6
adapters.
Reviewed by: gallatin, hselasky, kib (older version)
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D31572
Fix device detach and attach routine. Add required Makefile
to build as a module. Remove entry from GENERIC, since now
it can be loaded automatically.
Tested on EspressoBin.
Obtained from: Semihalf
Reviewed by: manu
Differential revision: https://reviews.freebsd.org/D31581
Fix 2.5 and 5G speeds reporting and update shared code with recent
changes:
- Update expected FW API versions for X710 and X722 adapters
- Define pointers related to Preservation Rules Module
- Add definitions for Shadow RAM pointers to new modules: 5th and 6th
FPA, and Preservation Rules Module.
- Add I40E_RX_PTYPE_PARSER_ABORTED definition, so the driver will know
opcode for parser aborted packets.
- Add the new filter types needed for custom cloud filters.
- Add support for Minimum Rollback Revision
- Fix RX_ONLY mode for unicast promiscuous on VLAN
- Add EEE LPI status check for X722 adapters
- Fix PHY type identifiers for 2.5G and 5G adapters
- Fix update link data for X722
- Increase the timeout value for PF reset to give PF more time to finish
reset if it is loaded with filters.
- Added support for Min Rollback Revision for 4 more X722 modules
- Fix reporting of Active Optical Cable media type
- Add flags and fields for double VLAN processing
- Fix potentially uninitialized variables in NVM code
Reviewed by: kbowling@, mike.jakubik@gmail.com
Tested by: gowtham.kumar.ks@intel.com
Sponsored by: Intel Corporation
Differential Revision: https://reviews.freebsd.org/D31565
Reject attempts to convert a connection using a different ULP
mode: (e.g. DDP or TLS) to ISCSI.
Reported by: Jithesh Arakkan @ Chelsio
Sponsored by: Chelsio Communications
Fix device detach and attach routine. Add required Makefile
to build as a module. Remove entry from GENERIC, since now
it can be loaded automatically.
Tested on EspressoBin.
Obtained from: Semihalf
Reviewed by: manu
Differential revision: https://reviews.freebsd.org/D31581
Fix detach routine.
Driver was tested on EspressoBin.
Remove it from GENERIC, since now it can be loaded automatically.
Obtained from: Semihalf
Reviewed by: manu
Differential revision: https://reviews.freebsd.org/D31580
Previosuly the link status was pooled in an infinite loop in a separate
kproc. Use taskqueue subsytem instead. This is a prequisite for making
this driver work as a loadable module.
Obtained from: Semihalf
Differential revision: https://reviews.freebsd.org/D31579
