For USS820 driver we need to manually reset TX FIFO at each SETUP transaction
because the chip doesn't do this by itself.
Submitted by: Hans Petter Selasky
It appears that some UVISOR devices do not handle when the clear stall command
is issued at the beginning of the initial IN/OUT data transfers. Reason
unknown, probably firmware fault. Now the stall is only cleared on data
transfer errors.
PR: usb/144199
Submitted by: Hans Petter Selasky
- make the usb_temp_setup() and usb_temp_unsetup() functions public so that
other modules can generate USB descriptors.
- extend the vendor specific request function by one length pointer argument,
because not all descriptors store the length in the first byte. For example
HID descriptors.
Submitted by: Hans Petter Selasky
Detect when we are polling from kernel via cngetc() in the boot process and
reserve the keypresses so they do not get passed to syscons.
Submitted by: Hans Petter Selasky
Add run(4), a driver for Ralink RT2700U/RT2800U/RT3000U USB 802.11agn devices.
This driver was written for OpenBSD by Damien Bergamini and ported over by
Akinori Furukoshi.
r204271:
Accessing an mbuf after it has been handed off to the hardware is a bad
race as it could already have been tx'd and freed by that time. Place
the bpf tap just _before_ writing the gen bit.
This fixes a panic when running tcpdump on a cxgb interface.
r204274:
There is no need to test __FreeBSD_version for features that have
been around for a long time now (7.1-ish or even earlier); assume
they are present. These includes MSI, TSO, LRO, VLAN, INTR_FILTERS,
FIRMWARE, etc.
Also, eliminate some dead code and clean up in other places as part
of this quick once-over.
r204348:
Support IFCAP_VLANHWTSO in cxgb(4). It works with or without vlanhwtag.
While here, remove old DPRINTFs and tidy up the capability code a bit.
r204921:
Better TwinAx transceiver detection.
Originally submitted by: <Bruno dot Bittner at isilon dot com>
(This is a rewritten, corrected version of that patch)
r205944:
Refresh the firmware version immediately after it is upgraded (or downgraded).
r205945:
Improved PHY EDC settings.
r205946:
Do not attempt to retrieve interrupt information before it is available.
r205947:
Fix build with "nooptions INET"
r205948:
Fix tx drop statistics.
r205949:
Fix signed/unsigned mix-up that allowed txq->in_use to grow beyond txq->size.
r205950:
Multiple fixes related to queue set sizing and resources:
- Only the tunnelq (TXQ_ETH) requires a buf_ring, an ifq, and the watchdog/timer
callouts. Do not allocate these for the other tx queues.
- Use 16k jumbo clusters only on offload capable cards by default.
- Do not allocate a full tx ring for the offload queue if the card is not
offload capable.
- Slightly better freelist size calculation.
- Fix nmbjumbo4 typo, remove unneeded global variables.
r206109:
Increase response queue size to avoid starvation, add a counter
to track it when it does occur.
Clean up some printing stuff so that we can have a bit finer control
on debug output. Add a new platform function requirement to allow
for printing based upon the ITL nexus instead of the isp unit plus
channel, target and lun. This allows some printouts and error messages
from the core code to appear in the same format as the platform's
subsystem (in FreeBSD's case, CAM path).
Revision 205075 and 205104:
---------205075----------
With the recent change of the sctp checksum to support offload,
no delayed checksum was added to the ip6 output code. This
causes cards that do not support SCTP checksum offload to
have SCTP packets that are IPv6 NOT have the sctp checksum
performed. Thus you could not communicate with a peer. This
adds the missing bits to make the checksum happen for these cards.
-------------------------
---------205104----------
The proper fix for the delayed SCTP checksum is to
have the delayed function take an argument as to the offset
to the SCTP header. This allows it to work for V4 and V6.
This of course means changing all callers of the function
to either pass the header len, if they have it, or create
it (ip_hl << 2 or sizeof(ip6_hdr)).
-------------------------
PR: 144529
