SVN r197174:
Make sure we never place the cursor outside the screen.
For some vague reason, it may be possible that scp->cursor_pos exceeds
scp->ysize * scp->xsize. This means that teken_set_cursor() may get
called with an invalid position. Just ignore the old cursor position in
this case.
Reported by: Paul B. Mahol <onemda gmail com>
SVN r198213:
Make lock devices work properly.
It turned out I did add the code to use the init state devices to set
the termios structure when opening the device, but it seems I totally
forgot to add the bits required to force the actual locking of flags
through the lock state devices.
Reported by: ru
SVN r198215, r198217:
Fix a typo in the jail(8) manpage.
Submitted by: Jille Timmermans <jille quis cx>
SVN r198216:
Fix qouting in a comment, to make it look more consistent
Submitted by: Jille Timmermans <jille quis cx>
SVN r198223:
Properly set the low watermarks when reducing the baud rate.
Now that buffers are deallocated lazily, we should not use
tty*q_getsize() to obtain the buffer size to calculate the low
watermarks. Doing this may cause the watermark to be placed outside the
typical buffer size.
This caused some regressions after my previous commit to the TTY code,
which allows pseudo-devices to resize the buffers as well.
Reported by: yongari, dougb
Workaround buggy BIOS code in USB regard. By doing the BIOS to OS handover for
all host controllers at the same time, we avoid problems where the BIOS will
actually write to the USB registers of all the USB host controllers every time
we handover one of them, and consequently reset the OS programmed values.
Fix the 106/109 USB Japanese keyboard "underscore" issue.
Sun Type 6 USB keyboard support added in rev 1.46 conflicted with
some scan codes used in Japanese keyboards because the scan code
conversion routine was ambiguous for the overlapped codes.
PR: ports/134005
Add extra safety locking when clobbering xfer->flags_int.started in start and
stop functions, because xfer->flags_int is also updated by the USB controller,
under the controller lock.
Import two PCI quirks from Linux
- Add quirk for ATI SB600 and SB700 to free SMB controller
- Correct schedule sleep time to 10us on the VIA ehci controller
We used force all of the GPIO pins low first and then
enable the ones we want. This has been changed to better
match the ADMtek's reference design to avoid setting the
power-down configuration line of the PHY at the same time
it is reset.
- FIFO's are always opened separately in read and write direction even if the
actual device is opened for read and write. Fix fflags check so that the UFM
and URIO drivers work.
Extract the code to find and map the MADT ACPI table during early kernel
startup and genericize it so it can be reused to map other tables as well:
- Add a routine to walk a list of ACPI subtables such as those used in the
APIC and SRAT tables in the MI acpi(4) driver.
- Move the routines for mapping and unmapping an ACPI table as well as
mapping the RSDT or XSDT and searching for a table with a given signature
out into acpica_machdep.c for both amd64 and i386.
Split the 'video' ACPI lock up into two locks to resolve a LOR with the
sysctl lock. The 'video' lock now protects the 'bus' of video output
devices attached to a graphics adapter. It is used when iterating over
the list of outputs, etc. The 'video_output' lock is used to lock the
output-specific data similar to a driver lock for the individual video
outputs.
