Tell the firmware that we support PCI-express config space access
and MSI.
Reviewed by: jkim
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D6023
This wrapper does not translate errors in the first word to ACPI
error status returns. Use this wrapper in the acpi_cpu(4) driver in
place of the existing _OSC code. While here, fix a bug where the wrong
count of words was passed when invoking _OSC.
Reviewed by: jkim
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D6022
le*dec / le*enc functions.
Replace net80211 specific macros with system-wide bytestream
encoding/decoding functions:
- LE_READ_2 -> le16dec
- LE_READ_4 -> le32dec
- LE_WRITE_2 -> le16enc
- LE_WRITE_4 -> le32enc
+ drop ieee80211_input.h include, where it was included for these
operations only.
Reviewed by: adrian
Differential Revision: https://reviews.freebsd.org/D6030
If we cannot establish compatibility by only looking at the compat_data we
also check the flash_devices structure's names for a compatible device.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D6026
The devtoname() name is strcpyed into a small stack buffer. Sure, we always
expect the name to be ttyXX (or ptyXX). If that's the case, strlcpy() doesn't
hurt.
Reported by: Coverity
CID: 1006768
Sponsored by: EMC / Isilon Storage Division
The local of the same name would alias the global, but we didn't even include
the header that defines tsc_freq. Include it and rename the local.
Reported by: Coverity
CID: 1331559
Sponsored by: EMC / Isilon Storage Division
This driver thinks that the NCT_MAX_PIN index is a valid index in a few places
(nct_attach() for-loop, as well as NCT_IS_VALID_PIN()). Allocate room for
NCT_MAX_PIN as an index, that is, NCT_MAX_PIN + 1 elements.
Reported by: Coverity
CIDs: 1353806, 1353807, 1353808, 1353809, 1353810
Sponsored by: EMC / Isilon Storage Division
No functional change, only trivial cases are done in this sweep,
Drivers that can get further enhancements will be done independently.
Discussed in: freebsd-current
and freed on as needed basis.
2. grcdump can be taken at failure points by invoking bxe_grc_dump()
when trigger_grcdump sysctl flag is set. When grcdump is taken
grcdump_done sysctl flag is set.
3. grcdump_done can be monitored by the user to retrieve the grcdump.
Submitted by:vaishali.kulkarni@qlogic.com
anything janky from a user. (cturt)
aac(4): landergriffith+freebsdbugzilla@gmail.com pointed out that aacraid(4)
had the same issue and handling of pointers, so let's change that too.
PR: 206573
Submitted by: cturt@hardenedbsd.org
Obtained from: HardenedBSD
MFC after: 1 week
This add a bhnd device table mechanism that standardizes matching of
devices on the bhnd(4) bus, discovery of device quirk flags, and should
be pluggable into the new PNPINFO machinery.
Submitted by: Landon Fuller <landonf@landonf.org>
Differential Revision: https://reviews.freebsd.org/D5759
To facilitate use by SoC implementors working with bhnd-inheriting fdt/nexus
drivers:
* Splits bhnd_bus method implementations into generic bus implementations
(bhnd_bus_generic) and generic bhnd(4) driver implementations (bhnd_generic)
* Simplifies bhnd resource handling, allowing bhnd bus implementations to
support bhnd resource activation by implementing the standard BUS_*
resource APIs and BHND_BUS_ACTIVATE_RESOURCE().
Submitted by: Landon Fuller <landonf@landonf.org>
Differential Revision: https://reviews.freebsd.org/D5758
This adds support for specifying the address space used by a bridge child;
this will either be the bridged SoC address space, or the host address space
required by children that map non SoC-address ranges from the PCI BAR.
This is necessary to support SROM/OTP child devices that live directly
beneath the bhndb device and require access to host resources, instead
of the standard behavior of delegating access to the bridged SoC address
space.
Submitted by: Landon Fuller <landonf@landonf.org>
Differential Revision: https://reviews.freebsd.org/D5757
Summary:
PowerPC Book-E SMP is currently broken for unknown reasons. Pull in
Semihalf changes made c2012 for e500mc/e5500, which enables booting SMP.
This eliminates the shared software TLB1 table, replacing it with
tlb1_read_entry() function.
This does not yet support ePAPR SMP booting, and doesn't handle resetting CPUs
already released (ePAPR boot releases APs to a spin loop waiting on a specific
address). This will be addressed in the near future by using the MPIC to reset
the AP into our own alternate boot address.
This does include a change to the dpaa/dtsec(4) driver, to mark the portals as
CPU-private.
Test Plan:
Tested on Amiga X5000/20 (P5020). Boots, prints the following
messages:
Adding CPU 0, pir=0, awake=1
Waking up CPU 1 (dev=1)
Adding CPU 1, pir=20, awake=1
SMP: AP CPU #1 launched
top(1) shows CPU1 active.
Obtained from: Semihalf
Relnotes: Yes
Differential Revision: https://reviews.freebsd.org/D5945
While here, adjust some whitespace and yeild some useful debug info.
This is untested on this hardware, testing requests to -scsi went
unanswered.
PR: 206585
Submitted by: cturt@hardenedbsd.org
MFC after: 2 weeks
can handle it, and add the code to add it to the FIS that's sent to
the drive. The mvs driver is the only other ATA driver in the system,
and its hardware doesn't appear to support setting the Auxiliary
register.
Differential Revision: https://reviews.freebsd.org/D5598
Since we no longer need additional buffers for request and response IOCBs,
we can increase receive space by 192 bytes, that is enough for fetching 48
more ports. The new limit is 1020 fabric ports per virtual port.
MFC after: 1 month
A lot of dts files define the SPI flashes supported by mx25l as
compatible with 'jedec,spi-nor', so we add this to the mx25l
compat_data.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5962
This revision gets our Mediatek/Ralink drivers closer to OpenWRT's dts
definitions, so we can reuse them with less modifications later in order
to bring support for a lot of boards at once.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5961
The ACPI and OFW PCI bus drivers as well as CardBus override this to
allocate the larger ivars to hold additional info beyond the stock PCI ivars.
This removes the need to pass the size to functions like pci_add_iov_child()
and pci_read_device() simplifying IOV and bus rescanning implementations.
As a result of this and earlier changes, the ACPI PCI bus driver no longer
needs its own device_attach and pci_create_iov_child methods but can use
the methods in the stock PCI bus driver instead.
Differential Revision: https://reviews.freebsd.org/D5891
Submitted by: Jun Su <junsu microsoft com>
Reviewed by: jhb, kib, sephe
Sponsored by: Microsoft OSTC
Differential Revision: https://reviews.freebsd.org/D5910
