Implement one CQ modify function supporting all firmware versions,
instead of having more variants of CQ modify.
MFC after: 1 week
Sponsored by: NVIDIA Networking
When using hardware pacing, this value can be increased, because more SQ's
means more EQ events aswell. Make it tunable, hw.mlx5.comp_eq_size .
MFC after: 1 week
Sponsored by: NVIDIA Networking
With clang 15, the following -Werror warning is produced:
sys/dev/mlx5/mlx5_core/mlx5_fs_tree.c:1408:15: error: variable 'candidate_group_num' set but not used [-Werror,-Wunused-but-set-variable]
unsigned int candidate_group_num = 0;
^
The 'candidate_group_num' variable appears to have been a debugging aid
that has never been used for anything, so remove it.
MFC after: 3 days
If the driver_version capability bit is enabled, send the driver
version to firmware after the init HCA command, for display purposes.
Example of driver version: "FreeBSD,mlx5_core,14.0.0,3.x-xxx"
Linux commits:
012e50e109fd27ff989492ad74c50ca7ab21e6a1
MFC after: 1 week
Sponsored by: NVIDIA Networking
Currently, unicast/multicast loopback raw ethernet (non-RDMA) packets
are sent back to the vport. A unicast loopback packet is the packet
with destination MAC address the same as the source MAC address. For
multicast, the destination MAC address is in the vport's multicast
filter list.
Moreover, the local loopback is not needed if there is one or none
user space context.
After this patch, the raw ethernet unicast and multicast local
loopback are disabled by default. When there is more than one user
space context, the local loopback is enabled.
Note that when local loopback is disabled, raw ethernet packets are
not looped back to the vport and are forwarded to the next routing
level (eswitch, or multihost switch, or out to the wire depending on
the configuration).
Linux commits:
c85023e153e3824661d07307138fdeff41f6d86a
8978cc921fc7fad3f4d6f91f1da01352aeeeff25
MFC after: 1 week
Sponsored by: NVIDIA Networking
This change adds convenience functions to setup a flow steering rule based on
a TCP socket. The helper function gets all the address information from the
socket and returns a steering rule, to be used with HW TLS RX offload.
MFC after: 1 week
Sponsored by: NVIDIA Networking
Add support to map an SQ to a specific schedule queue using a
special WQE as performance enhancement.
SQ remap operation is handled by a privileged internal queue, IQ,
and the mapping is enabled from one rate to another.
The transition from paced to non-paced should however always go
through FW.
MFC after: 1 week
Sponsored by: NVIDIA Networking
Create a wrapper for newbus to take giant and for busses to take it too.
bus_topo_lock() should be called before interacting with newbus routines
and unlocked with bus_topo_unlock(). If you need the topology lock for
some reason, bus_topo_mtx() will provide that.
Sponsored by: Netflix
Reviewed by: mav
Differential Revision: https://reviews.freebsd.org/D31831
While at it only output driver version to dmesg(8) when hardware is present.
Differential Revision: https://reviews.freebsd.org/D29100
MFC after: 1 week
Reviewed by: kib and markj
Sponsored by: NVIDIA Networking
Overview:
This is the first stage of a RDMA stack upgrade introducing kernel
changes only based on Linux 5.7-rc1.
This patch is based on about four main areas of work:
- Update of the IB uobjects system:
- The memory holding so-called AH, CQ, PD, SRQ and UCONTEXT objects
is now managed by ibcore. This also require some changes in the
kernel verbs API. The updated verbs changes are typically about
initialize and deinitialize objects, and remove allocation and
free of memory.
- Update of the uverbs IOCTL framework:
- The parsing and handling of user-space commands has been
completely refactored to integrate with the updated IB uobjects
system.
- Various changes and updates to the generic uverbs interfaces in
device drivers including the new uAPI surface.
- The mlx5_ib_devx.c in mlx5ib and related mlx5 core changes.
Dependencies:
- The mlx4ib driver code has been updated with the minimum changes
needed.
- The mlx5ib driver code has been updated with the minimum changes
needed including DV support.
Compatibility:
- All user-space facing APIs are backwards compatible after this
change.
- All kernel-space facing RDMA APIs are backwards compatible after
this change, with exception of ib_create_ah() and ib_destroy_ah()
which takes a new flag.
- The "ib_device_ops" structure exist, but only contains the driver ID
and some structure sizes.
Differences from Linux:
- Infiniband drivers must use the INIT_IB_DEVICE_OPS() macro to set
the sizes needed for allocating various IB objects, when adding
IB device instances.
Security:
- PRIV_NET_RAW is needed to use raw ethernet transmit features.
- PRIV_DRIVER is needed to use other privileged operations.
Based on upstream Linux, Torvalds (5.7-rc1):
8632e9b5645bbc2331d21d892b0d6961c1a08429
MFC after: 1 week
Reviewed by: kib
Differential Revision: https://reviews.freebsd.org/D31149
Sponsored by: NVIDIA Networking
Properly allocate all mlx5en(4) structures from correct numa domain.
While at it cleanup unused numa domain integers deriving from the
Linux version of mlx5en(4).
MFC after: 1 week
Reviewed by: kib
Sponsored by: Mellanox Technologies // NVIDIA Networking
Make sure the "uid" field gets properly set when destroying DCT and QP
objects by making a copy of the field when creating such objects.
MFC after: 1 week
Reviewed by: kib
Sponsored by: Mellanox Technologies // NVIDIA Networking
RoCE is short for Remote direct memory access over Converged Ethernet.
ECN is short for Explicit Congestion Notification.
MFC after: 1 week
Reviewed by: kib
Sponsored by: Mellanox Technologies // NVIDIA Networking
Querying the PCI config space for offline for every firmware command blocks
the PCI bus and affects performance. Especially for packet pacing and TLS
when objects are frequently created and destroyed.
MFC after: 1 week
Reviewed by: kib
Sponsored by: Mellanox Technologies // NVIDIA Networking
Make the mlx5e_mode_table[] array one dimensional, because there is only
one entry, 10G ER/LR, which share the same protocol bit.
This patch only adds support for basic sub-type distinguishing for the
extended protocol bits. Use verbose ifconfig eeprom output to get actual
media type.
Remove write only "connector_type" variable while at it.
MFC after: 1 week
Reviewed by: kib
Sponsored by: Mellanox Technologies // NVIDIA Networking
This code practically has not sleeping points, so Giant is locked for very
long time.
Noted and reviewed by: hselasky
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
-pci_get_class : This function search for a matching pci device based on
the class/subclass and returns a newly created pci_dev.
- pci_{save,restore}_state : This is analogous to ours with the same name
- pci_is_root_bus : Return true if this is the root bus
- pci_get_domain_bus_and_slot : This function search for a matching pci
device based on domain, bus and slot/function concat into a single
unsigned int (devfn) and returns a newly created pci_dev
- pci_bus_{read,write}_config* : Read/Write to the config space.
While here add some helper function to alloc and fill the pci_dev struct.
Reviewed by: hselasky, bz (older version)
Differential Revision: https://reviews.freebsd.org/D27550
This change include several changes as listed below all related to UAR.
UAR is a special PCI memory area where the so-called doorbell register and
blue flame register live. Blue flame is a feature for sending small packets
more efficiently via a PCI memory page, instead of using PCI DMA.
- All structures and functions named xxx_uuars were renamed into xxx_bfreg.
- Remove partially implemented Blueflame support from mlx5en(4) and mlx5ib.
- Implement blue flame register allocator.
- Use blue flame register allocator in mlx5ib.
- A common UAR page is now allocated by the core to support doorbell register
writes for all of mlx5en and mlx5ib, instead of allocating one UAR per
sendqueue.
- Add support for DEVX query UAR.
- Add support for 4K UAR for libmlx5.
Linux commits:
7c043e908a74ae0a935037cdd984d0cb89b2b970
2f5ff26478adaff5ed9b7ad4079d6a710b5f27e7
0b80c14f009758cefeed0edff4f9141957964211
30aa60b3bd12bd79b5324b7b595bd3446ab24b52
5fe9dec0d045437e48f112b8fa705197bd7bc3c0
0118717583cda6f4f36092853ad0345e8150b286
a6d51b68611e98f05042ada662aed5dbe3279c1e
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
- call pci_iov_detach() on detaching from PCI device to take care of hang
on destroying VFs after PF is down.
- disable eswitch SRIOV support right after pci_iov_detach(),
else the eswitch cleanup sometimes occur while the SRIOV flow table
is still present.
Submitted by: kib@
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
APIs that have deferred callbacks should have some kind of cleanup
function that callers can use to fence the callbacks. Otherwise things
like module unloading can lead to dangling function pointers, or worse.
The IB MR code is the only place that calls this function and had a
really poor attempt at creating this fence. Provide a good version in
the core code as future patches will add more places that need this
fence.
Linux commit:
e355477ed9e4f401e3931043df97325d38552d54
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
Report EQE data upon CQ completion to let upper layers use this data.
Linux commit:
4e0e2ea1886afe8c001971ff767f6670312a9b04
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
Enhance mlx5_core_create_cq() to get the command out buffer from the
callers to let them use the output.
Linux commit:
38164b771947be9baf06e78ffdfb650f8f3e908e
MFC after: 1 week
Sponsored by: Mellanox Technologies // NVIDIA Networking
