FC-Tape provides additional link level error recovery, and is
highly recommended for tape devices. It will only be turned on for
a given target if the target supports it.
Without this setting, we default to whatever FC-Tape setting is in
NVRAM on the card.
This can be overridden by setting the following loader tunable, for
example for isp0:
hint.isp.0.nofctape=1
sys/conf/options:
Add a new kernel config option, ISP_FCTAPE_OFF, that
defaults the FC-Tape configuration to off.
sys/dev/isp/isp_pci.c:
If ISP_FCTAPE_OFF is defined, turn off FC-Tape. Otherwise,
turn it on if the card supports it.
share/man/man4/isp.4:
Add a description of FC-Tape to the isp(4) man page.
Add descriptions of the fctape and nofctape options, as well as the
ISP_FCTAPE_OFF kernel configuration option.
Add the ispfw module and kernel drivers to the suggested
configurations at the top of the man page so that users are less
likely to leave it out. The driver works well with the included
firmware, but may not work at all with whatever firmware the user
has flashed on their card.
MFC after: 3 days
Sponsored by: Spectra Logic
pause() uses a spin loop to simulate a sleep during early boot. However,
we only need this for thread0 to get far enough in the boot process to
enable timers (at which point pause() can sleep). For other kthreads,
sleeping in pause() is ok as the callout will be scheduled and will
eventually fire once thread0 initializes timers.
Tested by: Steven Kargl
Sleuthing by: markj
MFC after: 1 week
Sponsored by: Netflix
file and add a generic DT binding that takes advantage of the extres
framework for setting up clocks.
Reviewed by: gonzo
Differential Revision: https://reviews.freebsd.org/D8826
use r92c_init_rf() rather than r92c_init_rf_common() when sc_init_rf()
callback is invoked.
While here, constantly use RF chain instead of RF path in comment.
Reviewed by: avos
For notes in KN_INFLUX|KN_SCAN state, the influx bit is set by a
parallel scan. When knote() reports event for the vnode filters,
which require kqueue unlocked, it unconditionally sets and then clears
influx to keep note around kqueue unlock. There, do not clear influx
flag if a scan set it, since we do not own it, instead we prevent scan
from executing by holding knlist lock.
The knote_fork() function has somewhat similar problem, it might set
KN_INFLUX for scanned note, drop kqueue and list locks, and then clear
the flag after relock. A solution there would be different enough, as
well as the test program, so close the reported issue first.
Reported and test case provided by: yjh0502@gmail.com
PR: 214923
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
This adds support for:
- Serializing an bhnd_nvram_plist (as exported from bhnd_nvram_store, etc) to
an arbitrary NVRAM data format.
- Generating a serialized representation of the current NVRAM store's state
suitable for writing back to flash, or re-encoding for upload to a
FullMAC device.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8762
properties backed by an NVRAM store.
This will be used to support:
- Serializing the current NVRAM state for writing back to flash.
- Exporting subsidiary device paths for serialization and upload to fullmac
chipsets.
Additionally, this includes an improvement to BCM-RAW format detection
to avoid matching on BCM-TEXT NVRAM data.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8761
Implements bhnd_nvram_store support for parsing and operating over NVRAM
device paths, and device path aliases, as well as tracking per-path NVRAM
variable writes.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8760
NULL (which we'll use to denote deleted values in bhnd_nvram_store), and
opaque data (aka octet-strings).
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8758
This adds support for bhnd_nvram_val_convert_init() and
bhnd_nvram_val_convert_new(), which may be used to perform value
format-aware encoding of an NVRAM value to a new target format/type.
This will be used to simplify converting to/from serialized
format-specific NVRAM value representations to common external
representations.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8757
representing arbitrary Broadcom NVRAM key/value pairs.
This will be used to track pending changes in bhnd_nvram_store, and
provide support for exporting all or a device subpath for NVRAM (as
required by some fullmac wifi chipsets).
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8756
The caller may unlink a prefix before purging referencing addresses. An
identical assertion in nd6_prefix_del() verifies that the addresses are
purged before the prefix is freed.
PR: 215372
X-MFC With: r306829
for INFORMATION field fit into available 4 bytes (has no non-zero bytes
except last 4), as explicitly required by SPC-5 specification.
MFC after: 2 weeks
The newvers -R option is intended to include build metadata (e.g. user,
host, time) if the build is from an unmodified VCS tree. For subversion
it considered a trailing 'M' as an indication of a modified tree, and
any other version string as modified.
Also include mixed revision checkouts (e.g. 123:126), switched (123S)
and partial (123P) working copies as modified: the revision number is
insufficient to uniquely determine which source was used for the build.
Reported by: gjb
Reviewed by: gjb
MFC after: 1 month
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8853
When WITH_REPRODUCIBLE_BUILD=yes is set in src.conf(5), eliminate the
time, user, and host from the loader's version information. This allows
builds to produce bit-for-bit identical output.
Reviewed by: bapt
MFC after: 1 month
Relnotes: yes
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8842
The Makefile rule to create vers.c for loader version info was
previously duplicated in each of the various loader Makefiles.
Instead, share a common rule in Makefile.inc.
Reviewed by: bapt
MFC after: 1 month
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8841
This can lead to change of mbuf pointer (packet filter could do m_pullup(),
NAT, etc). Also in case of change of destination address, tryforward can
decide that packet should be handled by local system. In this case modified
mbuf can be returned to the ip[6]_input(). To handle this correctly, check
M_FASTFWD_OURS flag after return from ip[6]_tryforward. And if it is present,
update variables that depend from mbuf pointer and skip another inbound
firewall processing.
No objection from: #network
MFC after: 3 weeks
Sponsored by: Yandex LLC
Differential Revision: https://reviews.freebsd.org/D8764
While CTL still has no real events to report in this way (like SMART),
it is possible to trigger false event by manually setting TEST bit in
Informational Exceptions Control mode page, that can be useful for
initiator testing. This code supports all flavours of IE reporting:
UNIT ATTENTION, RECOVERED ERROR and NO SENSE sense keys, REQUEST SENSE
command and Informational Exceptions log page.
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
boot panics in conjunction with the recently added EARLY_AP_STARTUP feature.
The panics happen due to using kernel facilities like callouts too early.
Tested by: jhb @
MFC after: 1 week
This 6 times gettimeofday performance, as measured by
tools/tools/syscall_timing
Reviewed by: kib
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8789
As noted in the removed comment, it is possible and not prohibitively
costly to look up the swap blocks for the given page index. Implement
a swap_pager_find_least() function to do that, and use it to iterate
simultaneously over both backing object page queue and swap
allocations when looking for shadowed pages.
Testing shows that number of new succesful scans, enabled by this
addition, is small but non-zero. When worked out, the change both
further reduces the depth of the shadow object chain, and frees unused
but allocated swap and memory.
Suggested and reviewed by: alc
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
enabled. This results in a -Werror warning in mlx4ib:
sys/dev/mlx4/mlx4_ib/mlx4_ib_sysfs.c:90:22: error: format specifies type 'unsigned long long *' but the argument has type 'u64 *' (aka 'unsigned long *') [-Werror,-Wformat]
sscanf(buf, "%llx", &sysadmin_ag_val);
~~~~ ^~~~~~~~~~~~~~~~
Change sysadmin_ag_val to unsigned long long to avoid the warning.
Reviewed by: hselasky
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D8831
