Allow userspace to retrieve low and high water marks, as well as the
current number of half open states.
MFC after: 1 week
Sponsored by: Modirum MDPay
(cherry picked from commit a6173e9463)
Allow SCTP state timeouts to be configured independently from TCP state
timeouts.
Reviewed by: tuexen
MFC after: 1 week
Sponsored by: Orange Business Services
Differential Revision: https://reviews.freebsd.org/D42393
(cherry picked from commit ca9dbde881)
A PF rule using an IPv4 address followed by an IPv6 address and then a
dynamic address, e.g. "pass from {192.0.2.1 2001:db8::1} to (pppoe0)",
will have an incorrect /32 mask applied to the dynamic address.
MFC after: 3 weeks
Obtained from: OpenBSD
See also: https://ftp.openbsd.org/pub/OpenBSD/patches/5.6/common/007_pfctl.patch.sig
Sponsored by: Rubicon Communications, LLC ("Netgate")
Event: Oslo Hackathon at Modirum
(cherry picked from commit 7ce98cf2f8)
Make Ethernet rules more similar to the usual layer 3 rules by also
allowing ridentifier and labels to be set on them.
Reviewed by: kp
Sponsored by: Rubicon Communications, LLC ("Netgate")
Introduce the OpenBSD syntax of "scrub" option for "match" and "pass"
rules and the "set reassemble" flag. The patch is backward-compatible,
pf.conf can be still written in FreeBSD-style.
Obtained from: OpenBSD
MFC after: never
Sponsored by: InnoGames GmbH
Differential Revision: https://reviews.freebsd.org/D38025
scrub rules have defaulted to handling fragments for a long time, but
since we removed "fragment crop" and "fragment drop-ovl" in 64b3b4d611
this has become less obvious and more expensive ("reassemble" being the
more expensive option, even if it's the one the vast majority of users
should be using).
Extend the 'scrub' syntax to allow fragment reassembly to be disabled,
while retaining the other scrub behaviour (e.g. TTL changes, random-id,
..) using 'scrub fragment no reassemble'.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D37459
Allow pf (l2) to be used to redirect ethernet packets to a different
interface.
The intended use case is to send 802.1x challenges out to a side
interface, to enable AT&T links to function with pfSense as a gateway,
rather than the AT&T provided hardware.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D37193
When syncookies are in adaptive mode they may be active or inactive.
Expose this status to users.
Suggested by: Guido van Rooij
Sponsored by: Rubicon Communications, LLC ("Netgate")
Fix a couple of problems with printing of anchors, in particular recursive
printing, both of inline anchors and when requested explicitly with a '*'
in the anchor.
- Correct recursive printing of wildcard anchors (recurse into child anchors
rather than rules, which don't exist)
- Print multi-part anchor paths correctly (pr6065)
- Fix comments and prevent users from specifying multi-component names for
inline anchors.
tested by phessler
ok henning
Also fix the relevant pfctl test case to reflect the new (and now
correct) behaviour).
MFC after: 3 weeks
Obtained from: OpenBSD (mcbride, f9a568a27c740528301ca3419316c85a9fc7f1de)
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D36416
When the interface does not exist avoid passing host with special pf
modifiers to DNS resolution as they come up empty anyway.
Reviewed by: kp
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D35429
While the kernel only performs the L3 check for
ETHERTYPE_IP/ETHERTYPE_IP6 we should always print the source and
destination addresses.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D34918
Allow filtering based on the source or destination IP/IPv6 address in
the Ethernet layer rules.
Reviewed by: pauamma_gundo.com (man), debdrup (man)
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D34482
When filtering Ethernet packets allow rules to specify a mac address
with a mask. This indicates which bits of the specified address are
significant. This allows users to do things like filter based on device
manufacturer.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Allow packets to be tagged with dummynet information. Note that we do
not apply dummynet shaping on the L2 traffic, but instead mark it for
dummynet processing in the L3 code. This is the same approach as we take
for ALTQ.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D32222
If we're not filtering on a specific MAC address don't print it at all,
rather than showing an all-zero address.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D31749
Extent pfctl to be able to read configured Ethernet filtering rules from
the kernel and print them.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D31738
We provide the hostid (which is the state creatorid) to the kernel as a
big endian number (see pfctl/pfctl.c pfctl_set_hostid()), so convert it
back to system endianness when we get it from the kernel.
This avoids a confusing mismatch between the value the user configures
and the value displayed in the state.
MFC after: 3 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D33989
Allow users to set a number on rules which will be exposed as part of
the pflog header.
The intent behind this is to allow users to correlate rules across
updates (remember that pf rules continue to exist and match existing
states, even if they're removed from the active ruleset) and pflog.
Obtained from: pfSense
MFC after: 3 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D32750
Allow pf to use dummynet pipes and queues.
We re-use the currently unused IPFW_IS_DUMMYNET flag to allow dummynet
to tell us that a packet is being re-injected after being delayed. This
is needed to avoid endlessly looping the packet between pf and dummynet.
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D31904
795d78a467 pfctl: Don't use PRIu64 mistakenly changed these to be
printed as hexadecimal numbers.
Reported by: Florian Smeets
MFC after: 4 days
Sponsored by: Rubicon Communications, LLC ("Netgate")
Rather than PRIu64 we can just treat the data as uintmax_t, and use %jx
instead.
MFC after: 1 week
Suggested by: kib
Sponsored by: Rubicon Communications, LLC ("Netgate")
Use PRIu64 to printf(3) uint64_t quantities, otherwise this will result
in "error: format specifies type 'unsigned long' but the argument has
type 'uint64_t' (aka 'unsigned long long') [-Werror,-Wformat]" on 32-bit
architectures.
Fixes: 80078d9d38
MFC after: 1 week
Rather than call DIOCGETSTATUS ourselves use the new libpfctl functions.
MFC after: 1 week
Sponsored by: Modirum MDPay
Differential Revision: https://reviews.freebsd.org/D31697
Support the 'match' keyword.
Note that support is limited to adding queuing information, so without
ALTQ support in the kernel setting match rules is pointless.
For the avoidance of doubt: this is NOT full support for the match
keyword as found in OpenBSD's pf. That could potentially be built on top
of this, but this commit is NOT that.
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D31115
As for example pfctl -ss keeps calling it, it saves a lot of overhead
from elided parsing of /etc/nsswitch.conf and /etc/protocols.
Sample result when running a pre-nvlist binary with nfs root and dumping
7 mln states:
before: 24.817u 62.993s 1:28.52 99.1%
after: 8.064u 1.117s 0:18.87 48.5%
Idea by Jim Thompson
Reviewed by: kp
Sponsored by: Rubicon Communications, LLC ("Netgate")
Allow up to 5 labels to be set on each rule.
This offers more flexibility in using labels. For example, it replaces
the customer 'schedule' keyword used by pfSense to terminate states
according to a schedule.
Reviewed by: glebius
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D29936
MAP-E (RFC 7597) requires special care for selecting source ports
in NAT operation on the Customer Edge because a part of bits of the port
numbers are used by the Border Relay to distinguish another side of the
IPv4-over-IPv6 tunnel.
PR: 254577
Reviewed by: kp
Differential Revision: https://reviews.freebsd.org/D29468
Introduce pfctl_pool to be able to extend the pool part of the pf rule
without breaking the ABI.
Reviewed by: kp
MFC after: 4 weeks
Differential Revision: https://reviews.freebsd.org/D29721
Stop using the kernel's struct pf_rule, switch to libpfctl's pfctl_rule.
Now that we use nvlists to communicate with the kernel these structures
can be fully decoupled.
Reviewed by: glebius
MFC after: 4 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D29644
When retrieving the list of group members we cannot simply use
ifa_lookup(), because it expects the interface to have an IP (v4 or v6)
address. This means that interfaces with no address are not found.
This presents as interfacing being alternately marked as skip and not
whenever the rules are re-loaded.
Happily we only need to fix ifa_grouplookup(). Teach it to also accept
AF_LINK (i.e. interface) node_hosts.
PR: 250994
MFC after: 3 days
ifa_grouplookup() uses the data loaded in ifa_load() (through is_a_group()), so
we must call ifa_load() before we can rely on any of the data it populates.
Submitted by: Nick Rogers
MFC after: 1 week
Sponsored by: RG Nets
r343287 / D18759 introduced ifa_add_groups_to_map() which is now run by
ifa_load/ifa_lookup/host_if. When loading an anchor or ruleset via pfctl that
does NOT contain ifnames as hosts, host() still ends up iterating all
interfaces twice, grabbing SIOCGIFGROUP ioctl twice for each. This adds an
unnecessary amount of time on systems with thousands or tens of thousands of
interfaces.
Prioritize the IPv4/6 check over the interface name lookup, which skips loading
the iftab and iterating all interfaces when the configuration does not contain
interface names.
Submitted by: Nick Rogers
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D24100
Setting the length of the request got lost in r343287, which means SIOCGIFGMEMB
gives us the required length, but does not copy the names of the group members.
As a result we don't get a correct list of group members, and 'set skip on
<ifgroup>' broke.
This produced all sorts of very unexpected results, because we would end up
applying 'set skip' to unexpected interfaces.
X-MFC-with: r343287
The number of syscalls made during parsing of any config that
defines tables is also reduced, and incorrect warnings that HFSC
parent queue bandwidths were smaller than the sum of their child
bandwidths have been fixed.
Reviewed by: kp
MFC after: 1 week
Sponsored by: RG Nets
Differential Revision: https://reviews.freebsd.org/D18759
When users mark an interface to not use aliases they likely also don't
want to use the link-local v6 address there.
PR: 201695
Submitted by: Russell Yount <Russell.Yount AT gmail.com>
Differential Revision: https://reviews.freebsd.org/D17633
In the pf rc.d script the output of `/etc/rc.d/pf status` or `/etc/rc.d/pf
onestatus` always provided an exit status of zero. This made it fiddly to
programmatically determine if pf was running or not.
Return a non-zero status if the pf module is not loaded, extend pfctl to have
an option to return an error status if pf is not enabled.
PR: 228632
Submitted by: James Park-Watt <jimmypw AT gmail.com>
MFC after: 1 week
Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
No functional change intended.
The tag fastroute came from ipf and was removed in OpenBSD in 2011. The code
allows to skip the in pfil hooks and completely removes the out pfil invoke,
albeit looking up a route that the IP stack will likely find on its own.
The code between IPv4 and IPv6 is also inconsistent and marked as "XXX"
for years.
Submitted by: Franco Fichtner <franco@opnsense.org>
Differential Revision: https://reviews.freebsd.org/D8058
