diff --git a/sys/boot/fdt/dts/arm/bcm2836.dtsi b/sys/boot/fdt/dts/arm/bcm2836.dtsi
index ab3db509b5f..bd75c843ca4 100644
--- a/sys/boot/fdt/dts/arm/bcm2836.dtsi
+++ b/sys/boot/fdt/dts/arm/bcm2836.dtsi
@@ -131,11 +131,11 @@
 			pinctrl-names = "default";
 			pinctrl-0 = <&pins_reserved>;
 
-			/* Pins that can short 3.3V to GND in output mode: 46-47
+			/* Pins that can short 3.3V to GND in output mode: 46
 			 * Pins used by VideoCore: 48-53
 			 */
-			broadcom,read-only = <46>, <47>, <48>, <49>, <50>, 
-			                     <51>, <52>, <53>;
+			broadcom,read-only = <46>, <48>, <49>, <50>,
+					     <51>, <52>, <53>;
 
 			/* BSC0 */
 			pins_bsc0_a: bsc0_a {
diff --git a/sys/boot/fdt/dts/arm/rpi2.dts b/sys/boot/fdt/dts/arm/rpi2.dts
index 59974f148ba..1c8c559b4da 100644
--- a/sys/boot/fdt/dts/arm/rpi2.dts
+++ b/sys/boot/fdt/dts/arm/rpi2.dts
@@ -322,18 +322,14 @@
 	leds {
 		compatible = "gpio-leds";
 
-		ok {
-			label = "ok";
-			gpios = <&gpio 16 1>;
+		pwr {
+			label = "pwr";
+			gpios = <&gpio 35 0>;
+		};
 
-			/* Don't change this - it configures
-			 * how the led driver determines if
-			 * the led is on or off when it loads.
-			 */
-			default-state = "keep";
-
-			/* This is the real default state. */
-			linux,default-trigger = "default-on";
+		act {
+			label = "act";
+			gpios = <&gpio 47 0>;
 		};
 	};