Support a agent health check performed by opening a TCP socket to a
pre-defined port and reading an ASCII string. The string should have one of
the following forms:
* An ASCII representation of an positive integer percentage.
e.g. "75%"
Values in this format will set the weight proportional to the initial
weight of a server as configured when haproxy starts.
* The string "drain".
This will cause the weight of a server to be set to 0, and thus it will
not accept any new connections other than those that are accepted via
persistence.
* The string "down", optionally followed by a description string.
Mark the server as down and log the description string as the reason.
* The string "stopped", optionally followed by a description string.
This currently has the same behaviour as down (iii).
* The string "fail", optionally followed by a description string.
This currently has the same behaviour as down (iii).
A agent health check may be configured using "option lb-agent-chk".
The use of an alternate check-port, used to obtain agent heath check
information described above as opposed to the port of the service,
may be useful in conjunction with this option.
e.g.
option lb-agent-chk
server http1_1 10.0.0.10:80 check port 10000 weight 100
Signed-off-by: Simon Horman <horms@verge.net.au>
While working on the changes required to make the health checks use the
new connections, it started to become obvious that some naming was not
logical at all in the connections. Specifically, it is not logical to
call the "data layer" the layer which is in charge for all the handshake
and which does not yet provide a data layer once established until a
session has allocated all the required buffers.
In fact, it's more a transport layer, which makes much more sense. The
transport layer offers a medium on which data can transit, and it offers
the functions to move these data when the upper layer requests this. And
it is the upper layer which iterates over the transport layer's functions
to move data which should be called the data layer.
The use case where it's obvious is with embryonic sessions : an incoming
SSL connection is accepted. Only the connection is allocated, not the
buffers nor stream interface, etc... The connection handles the SSL
handshake by itself. Once this handshake is complete, we can't use the
data functions because the buffers and stream interface are not there
yet. Hence we have to first call a specific function to complete the
session initialization, after which we'll be able to use the data
functions. This clearly proves that SSL here is only a transport layer
and that the stream interface constitutes the data layer.
A similar change will be performed to rename app_cb => data, but the
two could not be in the same commit for obvious reasons.
Some parts of the sock_ops structure were only used by the stream
interface and have been moved into si_ops. Some of them were callbacks
to the stream interface from the connection and have been moved into
app_cp as they're the application seen from the connection (later,
health-checks will need to use them). The rest has moved to data_ops.
Normally at this point the connection could live without knowing about
stream interfaces at all.
Instead of hard-coding sock_raw in connect_server(), we set this socket
operation at config parsing time. Right now, only servers and peers have
it. Proxies are still hard-coded as sock_raw. This will be needed for
future work on SSL which requires a different socket layer.
This patch turns internal server addresses to sockaddr_storage to
store IPv6 addresses, and makes the connect() function use it. This
code already works but some caveats with getaddrinfo/gethostbyname
still need to be sorted out while the changes had to be merged at
this stage of internal architecture changes. So for now the config
parser will not emit an IPv6 address yet so that user experience
remains unchanged.
This change should have absolutely zero user-visible effect, otherwise
it's a bug introduced during the merge, that should be reported ASAP.
